1. Identify the various materials and semi-finished products to be assembled with the connector;
2. Confirm the hole number of connector plastic parts;
A. Connector plastic parts on the 1st hole with "△" said;
B. No. 1 hole on the connector plastic is indicated by the number "1";
C. Connector plastic parts on the 1st hole with the "playing white point" said;
D. No holes or special circumstances;
3. Precautions before assembling the connector
A. Confirm the correct insertion direction of the terminals (face up or back up)
B. Confirm the correct insertion direction of connector plastic parts (some connector plastic parts can be assembled before and after)
C. Confirm double-row connector plastic parts of the left and right holes (usually one side, one side of the double)
D. Make sure the terminal and connector plastic parts are consistent, and some terminals can be inserted at the same time supporting the male and female connector plastic parts. (Under normal circumstances, the public terminal with female connector plastic parts, female terminal with male connector plastic parts, because these terminals can be inserted into the male and female connector plastic parts, so be sure to pay attention)
4. Precautions during assembly
A. Assembly is not in place (will affect the customer at the installation, the wire from the connector plastic out), so we have to pull back during assembly to confirm whether the terminal is fully inserted into the connector plastic parts.
B. Hole assembly error (also known as miswiring), this is the most serious assembly process errors, a direct impact on the safety of the machine, we must strictly control.
C. Products do not need to tie plastic or cable ties, the assembly should be careful not to wire.
D. Complex assembly, the first re-assembly of small holes into the porous connector plastic parts.
5. Group to pay processes
A. Verify that each group of wires in the group matches the product label on the group board.
B. Check the group to pay the nail is loose, see and understand the group pay the picture, special attention and important parts of the tolerance.
C. The product needs a good number of cable ties and tape, do a good job of quantity management, to avoid the group to pay when the leakage of plastic and leakage Zhadai.